WEKO3
アイテム
DSCによる凍結すり身の低温切断条件に及ぼす油脂含量の影響 <技術論文>
https://hiroshima.repo.nii.ac.jp/records/2011586
https://hiroshima.repo.nii.ac.jp/records/20115862d2868aa-f8a6-431f-b4e9-6648c37052af
名前 / ファイル | ライセンス | アクション |
---|---|---|
![]() |
Item type | デフォルトアイテムタイプ_(フル)(1) | |||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
公開日 | 2023-03-18 | |||||||||||||||||
タイトル | ||||||||||||||||||
タイトル | DSCによる凍結すり身の低温切断条件に及ぼす油脂含量の影響 <技術論文> | |||||||||||||||||
言語 | ja | |||||||||||||||||
タイトル | ||||||||||||||||||
タイトル | Effect of Oil Content on Optimum Conditions for Cryo-Cutting of Frozen Surimi, as Estimated by DSC. | |||||||||||||||||
言語 | en | |||||||||||||||||
作成者 |
岡本, 清
× 岡本, 清
× 羽倉, 義雄
× 鈴木, 寛一
|
|||||||||||||||||
アクセス権 | ||||||||||||||||||
アクセス権 | open access | |||||||||||||||||
アクセス権URI | http://purl.org/coar/access_right/c_abf2 | |||||||||||||||||
主題 | ||||||||||||||||||
主題Scheme | NDC | |||||||||||||||||
主題 | 590 | |||||||||||||||||
内容記述 | ||||||||||||||||||
内容記述 | Samples frozen surimi (ground fishmeat) with different moisture and cod oil contents were subjected to measurements of fracture stress (bending fracture energy) in a low temperature range (below 0°C). The optimum conditions for low-temperature cutting ("cryo-cutting") were estimated based on the enthalpy changes measured by a differential scanning calorimeter (DSC). Frozen surimi samples with moisture contents of 60∼90% and containing 1∼20% cod oil, which had frozen at -40°C, could not be cut by bending, but they could be cut at -80°C (temperature A). The melting temperature of cod oil, as determined by DSC measurement, but they was above -80°C. Thus, the surimi could be cut below the melting temperature of cod oil as detected by DSC. No significant decrease in the bending fracture energies of the surimi samples were measured below temperature A, and a glass transition was not observed on the DSC chart. It was considered that the presence of cod oil preverts glass transition in the surimi sample, because the melting temperature of cod oil overlaps with the glass transition range of surimi without oil. The results showed that the optimum cutting temperature was below -80°C, and that it could be estimated by DSC measurement. | |||||||||||||||||
言語 | en | |||||||||||||||||
内容記述 | ||||||||||||||||||
内容記述 | 水分と油脂含量の異なる凍結すり身の破壊エネルギー(破壊強度)を0℃以下の低温下で測定し, DSC測定の結果と比較することで, 凍結魚肉の低温切断加工の最適温度条件をDSC測定の結果から推定した. 水分60~80%, 油脂(タラ油)含量1~20%の凍結すり身を低温下で3点曲げ試験を行い, 破壊エネルギーを測定した. その結果, 試験片は-40℃で凍結していたが, 低温切断は-80℃以下の温度で可能となった. DSC測定の結果, 添加したタラ油の融解開始温度は, 切断可能温度である-80℃より高温側にあった. このようにタラ油を含んだすり身は, タラ油の融解開始温度以下で切断が可能であり, その融解開始温度はDSCにより測定が可能であった. 切断可能温度(温度A)以下での曲げ破壊エネルギーの急速な低下すなわち脆化は, 今回測定したサンプルでは確認できなかった. これらのサンプルのDSC測定では, ガラス転移様の変化が現れておらず, タラ油の融解温度範囲が水-すり身系でのガラス転移温度範囲と重なっていたことから, すり身に添加したタラ油が低温での脆化を抑制したことが示された. これらの結果から, 油脂を含む凍結すり身の低温での破壊挙動並びに低温切断に適切な凍結温度条件は, 試料のDSC測定結果から予測可能であり, それは-80℃以下に存在した. | |||||||||||||||||
言語 | ja | |||||||||||||||||
出版者 | ||||||||||||||||||
出版者 | 日本食品科学工学会 | |||||||||||||||||
言語 | ||||||||||||||||||
言語 | jpn | |||||||||||||||||
資源タイプ | ||||||||||||||||||
資源タイプ識別子 | http://purl.org/coar/resource_type/c_6501 | |||||||||||||||||
資源タイプ | journal article | |||||||||||||||||
出版タイプ | ||||||||||||||||||
出版タイプ | VoR | |||||||||||||||||
出版タイプResource | http://purl.org/coar/version/c_970fb48d4fbd8a85 | |||||||||||||||||
関連情報 | ||||||||||||||||||
識別子タイプ | DOI | |||||||||||||||||
関連識別子 | 10.3136/nskkk.53.70 | |||||||||||||||||
関連情報 | ||||||||||||||||||
識別子タイプ | DOI | |||||||||||||||||
関連識別子 | http://dx.doi.org/10.3136/nskkk.53.70 | |||||||||||||||||
収録物識別子 | ||||||||||||||||||
収録物識別子タイプ | ISSN | |||||||||||||||||
収録物識別子 | 1341-027X | |||||||||||||||||
収録物識別子 | ||||||||||||||||||
収録物識別子タイプ | NCID | |||||||||||||||||
収録物識別子 | AN10467499 | |||||||||||||||||
開始ページ | ||||||||||||||||||
開始ページ | 70 | |||||||||||||||||
書誌情報 |
日本食品科学工学会誌 日本食品科学工学会誌 巻 53, 号 1, p. 70-73, 発行日 2006-01-15 |
|||||||||||||||||
旧ID | 30168 |