Item type |
デフォルトアイテムタイプ_(フル)(1) |
公開日 |
2023-03-18 |
タイトル |
|
|
タイトル |
管状火炎バーナにおける高周波振動燃焼(熱工学,内燃機関,動力など) |
|
言語 |
ja |
タイトル |
|
|
タイトル |
High-Frequency Oscillatory Combustion in Tubular Flame Burners(Thermal Engineering) |
|
言語 |
en |
作成者 |
下栗, 大右
白神, 洋輔
石塚, 悟
石井, 一洋
藤, 秀実
|
アクセス権 |
|
|
アクセス権 |
open access |
|
アクセス権URI |
http://purl.org/coar/access_right/c_abf2 |
権利情報 |
|
|
権利情報 |
社団法人日本機械学会 |
権利情報 |
|
|
権利情報 |
本文データは学協会の許諾に基づきCiNiiから複製したものである |
主題 |
|
|
主題Scheme |
Other |
|
主題 |
Oscillating Combustion |
主題 |
|
|
主題Scheme |
Other |
|
主題 |
Swirl |
主題 |
|
|
主題Scheme |
Other |
|
主題 |
Noise |
主題 |
|
|
主題Scheme |
Other |
|
主題 |
Combustion |
主題 |
|
|
主題Scheme |
Other |
|
主題 |
Burner |
主題 |
|
|
主題Scheme |
Other |
|
主題 |
Tubular Flame |
主題 |
|
|
主題Scheme |
Other |
|
主題 |
Acoustic Oscillation |
主題 |
|
|
主題Scheme |
Other |
|
主題 |
Helmhortz Resonance |
主題 |
|
|
主題Scheme |
NDC |
|
主題 |
500 |
内容記述 |
|
|
内容記述 |
High-frequency oscillatory combustion in tubular flame burners has been experimentally investigated using two prototype burners of 1MW and 2MW. Oscillatory combustion regions have been mapped in the plane of equivalence ratio and air flow rate, and pressures fluctuations also have been recorded. Results show that large-amplitude, high-frequency oscillatory combustion occurs for near stoichiometric mixtures and when the mean axial velocity exceeds about 5m/s. With increasing the air flow rate, the oscillatory combustion region gradually expands on both lean and rich sides. According to FFT analyses, the peak frequencies during the oscillatory combustion exceed 1000Hz. A simple analysis shows that these high frequencies cannot be explained on the basis of the Helmholtz resonator, or attributed to the axial mode of acoustic instability of the burner tube. These high frequencies can be explained on the basis of coupling of tangential and radial modes of acoustic instability of the burner tubes. Just before the onset of the intense oscillatory combustion, the fundamental tangential mode, which is of asymmetry, appears, and during the subsequent intense oscillatory combustion, higher radial modes appear coupled with the asymmetric and symmetric tangential modes. Since the first asymmetric tangential mode of acoustic instability seems to trigger the intense, high-frequency oscillatory combustion, it is suggested to design the burner as symmetric as possible, and in addition, to make the flame as round as possible. |
|
言語 |
en |
出版者 |
|
|
出版者 |
一般社団法人日本機械学会 |
言語 |
|
|
言語 |
jpn |
資源タイプ |
|
|
資源タイプ識別子 |
http://purl.org/coar/resource_type/c_6501 |
|
資源タイプ |
journal article |
出版タイプ |
|
|
出版タイプ |
VoR |
|
出版タイプResource |
http://purl.org/coar/version/c_970fb48d4fbd8a85 |
関連情報 |
|
|
関連タイプ |
isVersionOf |
|
|
識別子タイプ |
NAID |
|
|
関連識別子 |
110007226604 |
収録物識別子 |
|
|
収録物識別子タイプ |
ISSN |
|
収録物識別子 |
0387-5016 |
収録物識別子 |
|
|
収録物識別子タイプ |
NCID |
|
収録物識別子 |
AN00187441 |
開始ページ |
|
|
開始ページ |
1197 |
書誌情報 |
日本機械学會論文集. B編
日本機械学會論文集. B編
巻 75,
号 753,
p. 1197-1204,
発行日 2009-05-25
|
旧ID |
31637 |